EasyMag Slider Mount and EasyMag Slider Mount XL
The EasyMag Slider Mount mag assembly is attached to a sliding horizontal tube that adjusts to any length from 2" to 6". This extends the suspended device well beyond the mount location, as desired.
The EasyMag Slider XL mount extends and suspends the attached device up to an incredible 12".
The mag assembly mounts on a 17mm ball providing 360 ° rotation, and up to 45° tilt in any direction. The 1.5" diameter neo magnet will handle any mobile device up to 20 oz. for instant attachment and removal.
Like other EasyMag mounts, the Slider is very solid and holds securely, utilizing the mat/cup combo design. However, the more the slider support tube is extended, the more some device wobble may be experienced, especially if used in a vehicle, and depending on road conditions. For desktop use, wobble is minimal.
If used in a vehicle, it is essential the dash surface be flat. Any curvature of the contour of the dash surface will result in less than desirable performance. If used on windshield, the mount is flipped upside down and adjusted to pitch as needed. For best performance always use the included 3" silicone mat. The cup/mat duo performance provides unrivaled holding power when properly seated.
The EasyMag Slider is adjusted by loosening two thumb screws on the front underside of the mount. Like other EasyMag mounts, a side knob allows adjustment for pitch.
The EasyMag Slider mount provides a relatively low profile height of 3". The mat footprint diameter is 3".
Maximum hold of the mat/cup suction design can be experienced on a solid, perfectly flat, smooth surface for many months without failure.
Hold duration times will vary on other surfaces.
It's not magic, it's MobileMount Solutions.